uniform deformation
英 [ˈjuːnɪfɔːm ˌdiːfɔːˈmeɪʃn]
美 [ˈjuːnɪfɔːrm ˌdiːfɔːrˈmeɪʃn]
网络 均匀变形
双语例句
- An advanced and practical achievement on property design while ensuring the uniform deformation of the heat-treated parts was obtained by means of numerical modeling method.
在既保证热处理零部件变形均匀性又实现性能设计的数值模拟方面取得了处于国际领先的成果。 - Influence of Chemical Compositions on Uniform Deformation and Work Hardening Behaviors of Metastable Austenite Stainless Steel Car Body Plates
化学成分对亚稳态奥氏体不锈钢车体板材均匀变形及加工硬化行为的影响 - Wide-band scanning makes the temperature distribution more uniform, the deformation smaller, and the previously treated area affected by the next scan less.
采用宽带扫描法可使温度分布更均匀，热处理引起的变形更小，同时减小下一道对前一道的热影响。 - The meso-deformation during the test process was manifested by uniform deformation.
剪切过程呈现良好的以均匀变形为主的细观变形特点。 - A model combining the rigid motion, block uniform strain and local deformation is used to describe the present-day activity and deformation of tectonic blocks in China's continent.
采用刚体运动+块体均匀应变+局部变形的模型作为描述中国大陆构造块体的现今活动和变形的模型。 - The uniform model of free-form deformation is studied.
研究了自由变形统一模型的问题。 - The analysis shows that the high carbon steel wires and low carbon steel wires can have stronger fiber texture [ 110] and uniform deformation. So it has a high strength and plastic target.
研究结果表明，高碳钢丝和低碳钢丝经过辊模拉拔能获得更强烈的〔110〕丝织构，变形均匀，具有较高的强度和塑性指标。 - Study on uniform deformation control of axial symmetrical H shaped forging
H形轴对称锻件变形均匀性控制的研究 - It is shown that deformation of clay has two types, one is manifested by uniform deformation, the other is manifested by local deformation.
研究结果表明，上海灰色粘土的变形有两种形式，一是以均匀性变形为主，二是以局部变形为主。 - Using the combined Rigidity Theory to treat the non-uniform deformation of foundations
应用联合刚度理论治理基础不均匀变形 - Study on Uniform Deformation Control of Forgings
锻件变形均匀性控制的研究 - Based on the localized instability theory, the limits of the internal pressure were calculated, and the UDL ( uniform deformation limitation) and the concept of LSR ( limited stress ratio) were proposed to check the basic workability of parts.
基于集中性失稳理论，计算了胀形压力极限，建立了均匀变形极限和极限应力比的概念，形成了零件可成形性的基本判据； - At the same time, difference of temperature field distribution between the sun_slope and the shade_slope will cause non_ uniform deformation of roadbed and cracking on the surface.
同时，路基阳坡、阴坡两侧地下温度场分布特征的差异构成了路基不均匀变形和路面裂缝的潜在威胁。 - According to the different deformation character of the duplex phase, the uniform deformation of dual phase steel divide into three stages.
根据两相不同的变形特征，把双相钢的均匀变形过程分为三个阶段。 - When uniform deformation condition is satisfied, superplastic materials will have very high plasticity.
均匀变形条件是超塑性材料迭到很高塑性的一个条件。 - Based on the curve of rheological process, it analyses the relation between the initial rheology and uniform rheology. It points out that there must exists the critical uniform rheological deformation of the soft interlayers.
根据流变过程曲线分析了起始流变与等速流变之间的关系，并指出软弱夹层的临界等速流变变形一定存在。 - The lithosphere of the Tarim basin shows rigid and uniform deformation, which enhances the transformation of force.
塔里木岩石圈呈刚性，且整体变形，对应力的传播起到放大的作用。 - The realization of uniform deformation of tube has great significance to improve surface accuracies of workpiece and strength of the joints by EMF.
如果能实现径向变形沿轴向均匀分布的要求，就可以提高电磁成形工件的表面质量及改善管管、管轴电磁连接的强度，对完善电磁成形理论具有重要意义。 - That the course of uniform plastic deformation before necking was divided into three stages in 290 ℃.
在290℃时，颈缩前的均匀塑性变形过程分为3个阶段。 - The Euler's vector and the entire uniform deformation parameters of the blocks with significant relative motion, as well as the local heterogeneous deformation within the blocks are derived. The pattern and rate of motion on active boundaries are also calculated.
求出了有明显相对运动块体的欧拉运动矢量和块体的整体均匀变形参数、各块体内部的不均匀局部变形以及活动边界的活动方式和强度。 - A Study on Uniform Deformation and Necking Velocity of Superplastic Material under the Condition of Uniaxial Tension
超塑性材料的单向拉伸均匀变形和颈缩速度的研究 - It is practically verified that this method exhibited less expense, easy operation, cast wall with uniform thickness, deformation decrease and cast defects reduction.
实践证明：该法铸造成本较低、操作简单，且铸件壁厚均匀、变形量小、铸造缺陷较少。 - Uniform deformation and dynamic stress equilibrium in the specimen are guaranteed by means of incident pulse shaping technique during the dynamic loading.
同时，采用输入波形整形技术，通过调整加载波形，使试样加载过程中保证均匀变形及应力平衡。 - A new uniform model of free-form deformation is proposed.
提出一个自由变形统一模型。 - The experiments indicate that the metal films under tension are experienced three stages: uniform deformation, the microcracks initiation and propagation, microcracks saturation.
研究表明：薄膜/基底结构在拉伸过程中薄膜经历了均匀变形、微裂纹形成扩展和微裂纹饱和三个阶段。 - With increasing pressure, the green densification is affected by non uniform deformation and changing inter-powder force.
随着冷压力的增大，冷压坯中粉末的变形不均匀、粉间摩擦力不断变化，均决定冷压坯的致密化过程。 - The aluminum foams deform from the top to the bottom under explosion load, which is different with the uniform deformation under quasi static loading and dynamic loading.
泡沫铝的波阻抗比较低，泡沫铝在爆炸载荷作用下从上到下发生压缩变形。这与其在准静态和动态情况下泡沫铝均匀的变形模式不同。 - Then it require the cooling process control and deformation control of the spray quenching institutions. This article through the analysis and establishing quenching temperature field and stress field of the finite element model. And studied the influence of parameters on the uniform temperature quenching deformation.
本文通过分析并建立淬火冷却温度场和应力场有限元模型，研究了各参数对温度均匀性淬火变形的影响。 - The results show: ( 1) Deformation of remoulded soil slopes has a stage of uniform deformation, which is not clear in structural soil slopes.
试验结果表明：（1）素土坡经历了明显的均匀变形阶段，而结构性土坡的均匀变形阶段不明显。